Lifts and Elevators Brisbane Australia - The Apollo

Specification

Australia by an Australian owned family company

AS1735 part 17

Residential only

Internal or external
Crane in or dismantle
The lift comes complete with tower, which can be fitted to an owner supplied shaft or have sheeting attached directly to the tower.
Cladding is to be in compliance with the lift code.

Water Hydraulic with direct acting cylinders on each side of the lift car

240volt 15amp

Up to 3.5m

Up to 0.10m/sec

250kg ( 2 people including 1 in a wheel chair)

Built as a free standing, self supporting unit, weighing approx 350kg the lift is fabricatedfrom aluminium. The tower comes complete with doors, door frames, flashing, electrical wiring and hydraulic cylinders

80mm

Individually built to the customers requirements up to a maxium floor space of 1.3m2
Standard Size - 900mm wide x 1300mm deep x 2000mm high with a clear door opening of 820mm

Single entry
Dual entry - through car

• Stainless steel handrail
• Non - slip floor covering indoor/outdoor carpet
• Emergency telephone
• Two recessed down lights
• 2 x Photo electric sensors across the door entrance

• Sliced pacific mapel
• Corinthian - Impression
• Metal with view panel
• Glass
  

Mounted on a stainless steel plate with protruding buttons the electric controls are automatic in operationKey lockable at the landings to prevent unwanted users. Illuminated indications Weatherproof stations are available for external landing stations

• Key lockable push button controls.
• Emergency stop button in the lift car
• Back up battery power for lighting & lowering of the car
• Emergency manual lowering facility provided in the machine cabinet
• 2x Photo- electric sensors across the door entrance
• A non-reversal timer of 5 seconds is fitted to allow the rider in the car to open the landing door once the car has stopped without the threat of the car being called by another operator.

Fabricated from metal and painted in silver hammer, the machine cabinet is suitable for external or internal installation.
The cabinet is fitted with a key lockable door and contains the hydraulic power unit, hydraulic control valves, electrical control board, emergency power supply and cabinet light.
The emergency tools and instructions are located within this cabinet.The cabinet size is 1800mm in height x 600mm in width x 300mm in depth

We recommend that the lift be serviced at no greater intervals than 12 months, this will ensure the lift is maintained in a safe and reliable condition.

12 months on all parts and labour excluding misuse and/or malicious damage.

• All building work such as the concrete slab, upper landing penetrations, barrier protection in the ceiling cavity and cladding to the external of the lift tower.
• Supply of a 240V. 15A electrical circuit to the Machine Cabinet.
• Supply and connection of a telephone line to the lift shaft terminating in the junction box provided by the lift installers (this can be an extension of the residence phone).
• Painting of the landing doors, as they are supplied prime painted only.
• Painting of the fibro infill inside the lift shaft between the two floors.